SGM Studio 12 User Manual download pdf (Page 50)

appendice

page 49

I D F E

This function, located in both the Light Chase Control and DMX Unit Control sections,

allows to output a light chase or a scanner program (according to the section in question) inde-

pendently of the Memory Registers.

Light chases and scanner programs can only be created in DIRECT mode.

These two controls are used to adjust scanner programs’ running speeds.

RATE indicates the program running time, SPEED the mirror (or moving head) movement time

and the passage from one effect to another with effects controlled in SOFT mode in the unit

library.

When this function is enabled, scanner programs run from scene 12 to scene 1 (they nor-

mally run from 1 to 12).

This function is used to put a program on pause at the required point. It doesn’t freeze

action, so if a Rotogobo function is enabled on one unit, it continues operating. If a scene cros-

sfade is running, it will be finished.

This function is used to store the scenes during program creation procedure and also to

add the program running to a Memory Register.

This button is used to enable the console’s Utilities, in which it’s possible to send Reset

and lamp on/off commands (to fixtures on which these functions are enabled) and to define and

control the scanning area of scanners or moving head fixtures.

This button enables the setup functions of the Scan Control section, in which the units in

the library are created, addressed and modified.

setup

util

store

pause

bkward

rate speed

min max

direct

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 61 62

No comments

SGM Studio 12 User Manual Page 50