SGM Synthesis Wash 700 Instruction Manual Page 24
- Page / 54
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
GB SGM Technology for lighting
User Manual 1.00 22 Synthesis
3.4
Structure of the menu
Here below are indicated the options composing Synthesis menu.
Menu
Options
Description
ADDRESS XXX Range 001-456 Fixture addressing
NORMAL Normal PAN control of left to right PAN movement.
PAN MOVE
REVERSE Inverted PAN movement control (from right to left).
PAN POS MIN Range 000-526 Sets PAN movement start position. Default configuration = 000 degrees
PAN POS MAX Range 004-530 Sets PAN movement stop position. Default configuration = 530 degrees
NORMAL Normal control of TILT from up to down.
TILT MOVE
REVERSE Inverted TILT movement control (from down to up).
TILT POS MIN Range 000-246 Sets TILT movement start position. Default configuration = 000 degrees
TILT POS MAX Range 004-250 Sets TILT movement stop position. Default configuration = 250 degrees
ON Data regarding Pan controls Tilt and vice versa.
PAN TILT SWAP
OFF Normal control of Pan and Tilt movement.
LAMP HOUR - Read only Menu. Stores lamp elapsed time. Can be reset.
LAMP STRIKE - Read only Menu. Stores the number of lamp strike. Can be reset.
SCANNER HOUR - Read only Menu. Stores fixture operating time.
DMX
DMX signal selected.
Automatic selection of the signal.
SIGNAL
RS-232
RS-232 signal selected.
Automatic selection of the signal.
ON Enables the DMX WIRELESS
WIRELESS
OFF Disable the DMX WIRELESS.
WIRELESS LOGOFF SET Disable the previous WIRELESS setting.
16 bit bitEnable the Pan\Tilt movement resolution 16 bit.
PAN TILT RES
8 bit bitEnable the Pan\Tilt movement resolution 8 bit.
HIGH RES Enable Focus and Gobos index 16 bit.
OPERATING
LOW RES
Enable Focus and Gobos index 8 bit, reducing the channels total
number.
TRACKING Traking operating mode. Mspeed channel is disabled.
SPEED CONTROL
VECTOR Vector operating mode. Mspeed channel is enabled.
ENABLE Remote lamp ignition enabled.
LAMP CONTROL
DISABLE Remote lamp ignition disabled.
ENABLE Remote reset enabled.
RESET CONTROL
DISABLE Remote reset disabled.
SPEED
100% - 92%
84% - 76%
Allows to slow maximum Pan and Tilt speed.
Default configuration = 100%
Fast Optimises speed performance.
ACCELLERATION
Slow Optimises smooth movement.
BRIGHTNESS
100-53-40-27
20-13-6-0(%)
Allows adjustment of display brightness.
Default configuration =40%
DISPAY FLIP -
Inverts display reading position. Used according to the position in which
the fixture is installed.
Range 8-600sec
It’s possible to set the number of second for which the fixture’s last
operating status must be held when there is no DMX signal.
DMX DELAY
UNL
Always maintains the fixture’s last operating status no matter for how
long there is no DMX signal.
SHUTTER
CLOSE=DS
Disables shutter closure in the event of pan/tilt loss of position.
SHUTTER CLOSE
SHUTTER
COLOSE=EN
Enables shutter closure in the event of pan/tilt loss of position.
FACTORY=SET Enables to set default parameters.
FACTORY
FACTORY=OFF Value during normal operation.
PREVIOUS=SET
Enables to restore the values of the parameters set immediately before
FACT=SET procedure.
PREVIOUS
PREVIOUS=OFF PREV value during normal operation.
- Table of Contents 3
- Symbols 4
- Changes to this manual 4
- General Warnings 5
- General warranty conditions 6
- 1 INTRODUCTION 7
- Accessories 8
- Electrical Specifications 9
- OPTICAL SYSTEM: 10
- SETTING: 10
- CONTROL SIGNAL: 10
- DMX CONTROL CHANNELS: 10
- Mechanical features 11
- 2 INSTALLATION 12
- Positioning the fixture 13
- Fitting clamps 14
- ABLES CONNECTIONS 15
- Firmware updating 17
- Pict. 1 18
- Pict. 2 18
- NSTALLING 19
- REPLACING THE LAMP 19
- AMP ALIGNMENT 20
- REPLACING THE COLOR FILTERS 22
- 3 MICRO COMPUTER CONTROL 23
- Structure of the menu 24
- Direction of Pan movement 27
- Direction of Tilt movement 28
- Limiting Tilt movement 28
- Pan/Tilt inversion 29
- Lamp elapsed time meter 29
- Lamp strike meter 29
- Fixture operating time meter 30
- Input signal 30
- Pan/Tilt movement resolution 30
- Wireless 31
- Wireless logoff 31
- Operating 31
- Speed Control 32
- Remote control lamp ignition 32
- Display brightness 33
- Display reading position 33
- Setting default parameters 34
- Test functions 35
- Reserved functions 36
- Temperature 36
- Version 36
- Error Messages 37
- 4 MAINTENANCE 38
- UFFER BATTERY REPLACEMENT 39
- AMP REPLACEMENT 39
- 5 CONTROL CHANNELS 40
- ESCRIPTION 41
- Iris (Ch5) 42
- Color Mode (Ch20) 42
- Gobo Wheel 1 (Ch7) 43
- Shutter / Strobe (Ch8) 44
- Dimmer (Ch9) 44
- Prism/ Beam expander (Ch11) 44
- Prism Rotation (Ch12) 44
- Electronic Focus (Ch13) 45
- Zoom (Ch14) 45
- Animation wheel Mode (Ch15) 45
- Frost (Ch16) 45
- Mspeed (Ch17) 45
- Gobo1 shake (Ch19) 46
- Macro (Ch22) 47
- Gobo Wheel 2 (Ch24) 47
- Macro(Ch22) 49
- Gobos2 channel mode (Ch27) 49
- Gobo2 shake (Ch28) 50
- Cyan ( Ch31 ) 50
- Magenta (Ch32) 51
- Yellow (Ch33) 51
- CTO (Ch34) 51
- Conversion Table 52
Related products and manuals for Floodlights SGM Synthesis Wash 700
Floodlights SGM Studio 12 User Manual
(63 pages)
(63 pages)
(24 pages)
Floodlights SGM Pilot 2000 User Manual
(73 pages)
(73 pages)
Floodlights SGM Pilot 2000 User Manual
(22 pages)
(22 pages)
Floodlights SGM Studio 12 User Manual
(13 pages)
(13 pages)
Floodlights SGM Giotto spot 400 User Manual
(36 pages)
(36 pages)
Floodlights SGM Studio 12 User Manual
(12 pages)
(12 pages)
Floodlights SGM Studio 12 User Manual
(63 pages)
(63 pages)
Floodlights SGM Studio 12 User Manual
(62 pages)
(62 pages)
Floodlights SGM PALCO 3 User Manual
(18 pages)
(18 pages)
Floodlights SGM Pilot 2000 User's Guide
(29 pages)
(29 pages)
Floodlights SGM Studio 12 User's Guide
(29 pages)
(29 pages)
© 2020, manymanuals.com. All rights reserved. | 1.309 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals