STUDIO SC USER GUIDE
Chase Section
To set up a chase:
1. Put the Direct fader to full and push the button underneath
2. Press and hold down the Chase button
3. Press the number of the chase required on the B master section. This LED will now
flash
4. Release the Chase button
5. Press the Edit button. This LED will now flash
6. Press and hold the Step button
7. Select the step number, if setting up a chase this will be the number one. Press the
button under the number one fader on the B preset section. The green LED on the
button will flash
8. Release the Step button
9. Select the channels to be in that step by pressing the button underneath each channel
or setup the light output level of each channel by rising the channel fader to the desired
value.
10.The step is now recorded, to record further steps then repeat numbers 6 to 9.
11. Press Edit when all steps of the chase have been plotted or modified.
To run a chase:
1. Put the Direct master to zero
2. Press the Direct button
3. Press and hold down the Chase button
4. Select the chase number required on the buttons under the B presets section. The
green LED will now flash
5. Release the Chase button
6. Rise the Direct master to full, the chase will now run
7. Fade out the chase by fading the Direct master to zero
8. To de-select the chase, press and hold down the Chase button and press the chase
number previously selected. The green LED will stop flashing.
To select the steps to be run:
Not all the steps of a chase need be run, despite being plotted.
1. Select the chase as above
2. Press and hold the Step button
3. Deselect or select steps as required. A step is selected if the green LED is lit
4. Release the Step button
Set the time of a Chase:
The speed of a chase will run is decided using the Rate and Slope knobs above the Step
and Edit buttons.
SGM Light Technology 12/12/2000 Ver. 2.04
9
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals